Aerated air source heat pump for aquaculture
Special heat pump
- Details Introduction
-
- Commodity name: Aerated air source heat pump for aquaculture
In the whole process of aquaculture, constant temperature is one of the links. If the temperature is too low, the amount of diet will decrease, which may lead to death. If the water temperature exceeds 33 ℃, the resistance will decrease and it is easy to get sick. Therefore, the control of water temperature is particularly important!
Why does aquaculture need constant humidity?
In the whole process of aquaculture, constant temperature is one of the links. If the temperature is too low, the amount of diet will decrease, which may lead to death. If the water temperature exceeds 33 ℃, the resistance will decrease and it is easy to get sick. Therefore, the control of water temperature is particularly important!
As the saying goes: fish first raise water, water temperature is very important!
Aquaculture water quality indicators: temperature, salinity, PH value, dissolved oxygen, ammonia nitrogen, nitrite, etc.
Temperature requirements throughout the entire breeding process
The intelligent breeding scheme will break down one by one for you!!!
5 advantages of special aerated air source heat pump for aquaculture


6 characteristics of special aerated air source heat pump for aquaculture

Flexible design and easy installation
Integral design, beautiful and compact appearance of the unit, easy to install
Durable
Adopt international brand compressor, advanced titanium metal water heat exchanger, strong corrosion resistance, stable performance, durable
Safe and reliable
Water and electricity isolation, no combustion, no leakage during operation, completely eliminate the risk of electric shock, poisoning and so on
intelligent control
The unit can be connected to the network or mobile phone to realize remote monitoring
Energy saving and environmental protection
The unit has high energy efficiency ratio and large heating capacity. Compared with other regular heat pumps, it can save 65% ~ 80% of operating costs and has no pollution to the environment.
Strong oxygenation
The concentration of up to 93% oxygen dissolved in water, water oxygen content can reach twice the traditional oxygenSpecial aerated air source heat pump heat for aquaculture

Special aerated air source heat pump for aquaculture:
1. Using the reverse Carnot principle, the refrigerant carrier is used to absorb or release heat from the air, and at the same time, the water temperature of the breeding pond is raised or lowered through the heat exchanger, and finally the set temperature is reached to realize the constant temperature breeding.
The. The unit has a built-in oxygen generation module. After the air is processed by multiple layers of the module, it outputs gas with an oxygen content of 93%, and the oxygen content in the aquaculture pond water can reach twice that of the traditional oxygen increase.
Comparison of operating costs of different heating modes of aquaculture constant temperature
Heating mode
electric boiler
natural gas boiler
coal boiler
air energy heat pump
Type of fuel
Electricity
Natural gas
Coal
Electricity
combustion value(Kcal)
860Kcal/Kwh
8700KcaVm3*h
6500Kcal/Kg
860Kcal/h
Efficiency(Annual average efficiency)
95%
85%
75%
350%
Energy Demand
1224
135
205
332
correction coefficient
1.1
1.1
1.1
1.1
hourly energy consumption
1346Degree
148.5m3
225.5kg
365Degree
Unit price(Yuan)
0.7
3
0.5
0.7
Total fuel price(Yuan)
942
445.5
180.5
225.5
Heat pump scheme is the best solution for constant temperature aquaculture.
Note: The operating cost is the cost comparison based on the theoretical calculation of heat load. The actual heat deviation leads to the cost deviation, but does not affect the comparison result of the cost.
1. The above cost is different heating methods to heat 100 tons of water to heat up 10℃Comparison of costs;
2. The price of fuel in the table is as follows: Electricity charge is 7 gross/degree, natural gas 3 yuan/square, coal 800 yuan/ton;
3. The labor cost of burning coal is not calculated, and the operating cost of heat pump is almost the same as that of burning coal when the electricity cost is 5 cents;Special aerated air source heat pump for aquaculture
Specifications:
Model
KBKR-Y5CS/D
KBKR-Y10CS/D
KBKR-Y30CS/D
KBKR-Y50CS/D
Rated heating capacity(Kw)
17
34
95.2
170
Heating input power(Kw)
3.9
7.8
20
36
Coefficient of performance
4.36
4.36
4.76
4.72
Rated refrigerating capacity(Kw)
18
36
108
180
Refrigeration input power(Kw)
4
8
24
40
energy efficiency ratio
4
4.5
4.5
4.5
Maximum input power(Kw)
5.2
10.4
31
52
Power Supply Specifications
380V 3N~/50Hz
Application of temperature range(℃)
-25~43
Circulating water volume(m3yh)
7.3
14.6
40.9
73.1
NoisedB(A)
54
60
67
68
Protection level
IPX4
Oxygen increase(L/min)
10
10
30
50
Constant temperature water quantity(m3)
25
45
150
225
Overall dimension(mm)
1520*880*1050
1490*910*1560
2200*1055*2020
2245*1300*2145
Source line specifications(mm2)
2.5
6
16
25
Note:Rated heating condition:Environment dry/wet bulb temperature7/6℃,Backwater/Outlet water temperature26/28℃.
Rated refrigeration condition: Environment dry/wet bulb temperature35/27℃,Backwater/Outlet water temperature34/32℃.
Heating and fixed water yield: Environment dry/wet bulb temperature7/6℃,initial water temperature15℃,Terminate water wet40℃.
The above parameters are for reference only,The actual fuselage nameplate shall prevail!

Key words:
Lean equipment
Previous
Product Message
Get in touch with our team in a timely manner and be happy You offer help
* Note: Please be sure to fill in the information accurately and keep the communication unblocked. We will get in touch with you as soon as possible.